Razorweld RAZORCUT45, Инструкция по эксплуатации

Страница: 8 / 36

Page 8
1.2. Other precautions
Warning! Location
The machine should be located in a suitable position and environment. Care
should be taken to avoid moisture, dust, steam, oil or corrosive gases. Place
on a secure level surface and ensure that there is adequate clearance around
the machine to ensure natural airflow.
Warning! The handle or strap on the machine is only suitable for manual
lifting of the machine. If mechanical equipment such as crane is used to lift
the machine, please ensure the machine is secured with suitable lifting
equipment.
Warning!
Input connection
Before connecting the machine, you should ensure that the correct supply is
available. Details of the machine requirements can be found on the data plate
of the machine or in the technical parameters shown in the manual. The
equipment should be connected by a suitably qualified competent person.
Always ensure the equipment has a proper grounding.
Never connect the machine to the mains supply with the panels removed.
1) When the operator's movement is limited by the surroundings (for example, the operator
can only bend his knees, barefoot, or lie down during operation), the operator shall practice
proper insulation and avoid direct contact with conductive parts on the equipment.
2) Do not use the machine in closed containers in narrow spaces where conductive
components cannot be removed.
3) Do not use the machine in humid environments where the operator is prone to the risk of
electric shock.
4) Do not use the machine in sunlight or rain, and no water or rainwater shall seep into the
machine.
5) Do not perform gas shielded welding in an environment with strong air flow.
6) Avoid welding or cutting in dusty area or environment with corrosive chemical gas.
7) The ambient temperature must be between-10°C and 40°C (14F - 104F) during operation
and between-25°C and 50°C during storage. (-13 - 122F)
8) Welding or cutting shall be carried out in a relatively dry environment, and the air
humidity shall not exceed 90%.
9) The inclination of the machine shall not exceed 10°.
10) Ensure that the input power supply voltage does not exceed 15% of the rated voltage
of the machine.
11) Beware of falling when welding or cutting at heights.