Razorweld RAZORCUT45, Инструкция по эксплуатации

Страница: 16 / 36

Page 16
6.3. Parameter adjustment knob
1) Rotate the adjusting knob to adjust the parameters.
2) Rotating the adjusting knob clockwise increases the parameter value, and rotating the
adjusting knob counterclockwise decreases the parameter value.
3) When the adjusting knob is rotated the adjusted parameters are displayed in the
parameter display area.
6.4. Selection of working mode
1) Press the cutting mode selection button while not cutting to switch between the
three cutting modes as needed: 2T, 4T and mesh cutting.
2) If the indicator is on, it indicates that the machine is currently in 2T cutting mode.
3) If the indicator is on, it indicates that the machine is currently in 4T cutting mode.
4) If the indicator is on, it indicates that the machine is currently in mesh cutting mode.
6.5. Gas check function
1) Press the gas check button while not in cutting state.
2) When the indicator is lit, the machine is in gas check mode.
3) Press the gas check button again or wait 20s. After the indicator light goes out, the
machine has exited gas check mode.