Razorweld RAZORCUT45, Инструкция по эксплуатации

Страница: 19 / 36

7.1.2 Select the most appropriate cutting mode as needed: 2T or 4T continuous cutting, or
mesh cutting.
7.1.3 Select the appropriate cutting current level according to the thickness of the sheet. The
rotary encoder will adjust the electric current parameters.
Quick reference table for CUT45PFC cutting process ( F t /min) approximate only!
NOTE! The operator should set the functions that meet the cutting requirements . If the
selections are incorrect, this may lead to problems such as an unstable arc,
incomplete cutting, more dross, rough cutting surface and heavy consumables
consumption and etc.
7.1.4 Start Cutting
2T continuous cutting: When the main arc is extinguished due to lack of base material, the
cutting machine automatically cuts off the output. You must release the torch trigger and
press it again to re-establish the pilot arc and keep cutting.
4T continuous cutting: When the main arc is extinguished due to lack of base material, the
cutting machine automatically transfers to pilot arc output, and the pilot arc can be
re-established and cutting continued without releasing the torch trigger.
Mesh cutting: When the main arc is extinguished due to missing workpieces, the cutting
machine automatically establishes a pilot arc and maintains it for a certain period of time.
When the pilot arc contacts the workpiece and ignites the main arc, cutting can continue. In
mesh cutting mode, the machine automatically locks 2T/4T mode to 2T mode.
7.1.5 Turn off the power supply after cutting
The power switch is located on the rear panel of the machine and set it to the "off" position.
After a time delay, the panel indicator is off and the machine stops working.
Page 19
CUTTING CAPACITY FEET/MINUTE