that manual tuning for that particular frequency can now be actu-
ated.
Use the (up) or (down) key to shift the frequency tuning in small
increments. While observing the A-Scope presentation, tune for the maxi-
mum echo strength indications on the display. The bar indicator and the
digital indicator at the right edge of the
show the actual
frequency tuned.
In practice, it’s a good idea to preset the echosounder for the tuning
calibration
by
first
selecting
control operation in the
DER
menu and then by setting the range scale of the Fishfinding
deep enough to show all of the possible echo returns on the A-scope when
the receiver gain is set to maximum for tuning each frequency.
An example of the manual tuning process for the 200 Khz transmitter
would be to select the STD Fishfinding screen. Verifythe 200 Khz frequency
was in use. Check the Gain A control and verify it is controlling the screen
sensitivity level by rotating the control and observing the echoes and noise
level. Press
and set the range scale to about 150 to 200 feet.
Press the-key, and then
from the menu with the
and
Press
for tuning the 200Khz transmitter. While watching the
weak echoes at the bottom end of the A-Scope, use the
up or
down
direction keys to adjust for the maximum number or strongest levels of the
echo returns.
Press the
again to return the unit to the
tune mode
and verify that after a few seconds in
AUTO
the echoes on the A-Scope
remain at maximumlevels.
3.6.4 Master Reset
The
key restores the
operating screens to an “operator
preset” condition. The
also includes a
MASTER
mode. The
differs from the
CUSTOM
mode in that anytime you
all
routes, and event memories and start again
with the original factory set-up conditions, a
MASTER RESET
can be per-
formed, as follows:
OPERATION
111
Содержание V8010
Страница 2: ...WCOLOR ECHO SOUNDER OPERATlON MANUAL...
Страница 16: ...1 q i z INTRODUCTION 8...
Страница 20: ...8 1 205 mm 13 07 _l m 332 mm Y OUTLINE DIdENS O S MI010 ECHO SOUNDER INSTALLATION 12...
Страница 127: ...MAINTENANCE...