Raytheon Electronics ST6000 Plus, Руководство пользователя

Страница: 60 / 90

48 ST6000 Plus Autopilot Control Unit Owner’s Handbook
D3243-2
1 4 2 3
8. Assemble the control head to the bulkhead.
9. Secure the control head with the thumb nuts (3) provided. Tighten
the thumb nuts BY HAND. Do NOT use a wrench.
Flush mounting
To fit a flush mount control head:
1. Ensure that the panel on which you intend to mount the control
head is between 3 mm and 20 mm thickness.
2. Apply the flush mount template (supplied near the rear of this
handbook) to the selected location and mark out the aperture into
which the control head will sit.
3 Cut out the aperture (3) for the control head and remove the
template.
4. Peel off the protective sheet from the self-adhesive gasket (4) then
stick the gasket into position on the rear of the control head bezel.
5. Screw the two fixing studs (1) into the threaded sockets on the rear
of the control head.
6. Pass the cables (SeaTalk, power, compass etc.) through the
bulkhead and connect them to the appropriate terminals (see
relevant subsection for connection details).
133_3c05.p65 14/06/99, 10:24 48