Raytheon Electronics ST6000 Plus, Руководство пользователя

Страница: 66 / 90

54 ST6000 Plus Autopilot Control Unit Owner’s Handbook
Navigation interface (GPS, Decca, Loran)
If the ST6000 Plus is interfaced to a navigator, via its NMEA data port,
the interface can be checked by displaying the default Data Pages.
These are
XTE, BTW
, and
DTW
.
Press
disp
to display the first page, and check that the expected data is
displayed. Press
disp
again to check each successive page.
If dashes are displayed instead of data values, the cause could be one or
more of the following:
• A cabling error. Check for an open circuit, short circuit or reversed
wires.
• The navigator is not configured to transmit the required data format.
• The signals being received by the navigator are too weak for reliable
navigation. Refer to the navigator handbook for further action.
SeaTalk interface
If the ST6000 Plus has been linked to other SeaTalk instruments via
SeaTalk, the link can be checked as follows:
1. Press
standby
.
2. Select display illumination level 3 on any other SeaTalk instrument
or autopilot control unit.
The ST6000 Plus should immediately respond by switching on its
display illumination.
If the illumination does not switch on then a cabling fault exists in the
SeaTalk cabling between the ST6000 Plus control head and the
instruments/control unit.
133_3c05.p65 14/06/99, 10:24 54