6
The only functions of the Remote Control available during Operating Mode
is LED Status Indicators Enable/Disable (see section 5), entering a PIN
(see section 10) or disabling manual buttons (if done at the same time as
disabling the remote).
Factory Default: On initial power-up, illuminator automatically
defaults into programming mode. Programming mode automatically
disabled after 7 days or until the user actively disables the
programming mode or the unit times out 30 minutes after any
press of the manual buttons on the illuminator.
VARIO2 Hybrid: Programming mode automatically disabled after
4 weeks
2. Power Adjust
The power output of the VARIO2 illuminator can be adjusted between 5
pre-set levels. To select the required light intensity, use the buttons shown.
Factory default = 100% power.
80% of maximum
60% of maximum
40% of maximum
20% of maximum
100% of maximum
