13
7. Disable Remote Control Set-up
The security features implemented in the VARIO2 illuminator and
VARIO2 remote control are designed to ensure that the system
cannot be programmed by unauthorized personnel. The system
is automatically in programming mode once the illuminator is
powered up. Once the installer/user has finished programming the settings
of the VARIO2 illuminator, they can choose to lock-in these settings by
pressing the ‘Disable Remote Set-up’ button.
To disable the remote control, continuously press the ‘Disable Remote
Control’ button for 4 seconds. When the remote control is disabled, and the
illuminator is in Operating mode the RHS LED indicator is Off. After 7 days
of continuous power the illuminator will automatically disable the remote
and change to Operating mode.
Please note: To enable programming mode again after remote set-
up has been disabled, the VARIO2 illuminator must be powered off
(for at least 10 seconds) then on again - the illuminator will then
automatically re-enter programming mode.
(If a PIN security code has been set, further actions are required to enable
programming mode – Please refer to the illuminator Instruction Guide)
We would normally recommend disabling remote set-up once you have
finished programming an individual VARIO2 illuminator and are satisfied that
it is delivering the required operating performance. This will help to avoid
tampering and the possibility of receiving commands when programming
other units in close proximity.
