Raypak 910500, Руководство пользователя и инструкции по установке

Страница: 92 / 108

92
Refer to the following for BOILER Menu tables/items.
BOILER Menu Tables
The BOILER screen has two main pages which can be entered as follows:
1.
BOILER > Boiler X (where 'X' is the heater number i.e. 1, 2, 3 or 4).
PAGE 1
– Expanded Boiler Screen (View only)
ITEM DISPLAYS NOTES
Identity Water heater type i.e. H, WH -
Ignition Type Ignition type HSI Hot surface ignition
ID Card ID card identification number -
Governor PID PID burner modulation control
Fire Rate % firing rate of burner Current PIM modulation level
Outlet Temp Outlet water temp in °C -
Inlet Temp Outlet water temp in °C -
Ignition
Idle (no CFH), Prepurge, IgnTry1 (trial for
ignition), Burn (burner on), Postpurge,
HardLock (hard lockout), SoftLock (soft
lockout) SoftLock = A soft lockout has occurred that
interrupted the heating cycle. The CFH will
resume after fault correction & expiry of 16
min
Limit Temp Manual reset high limit fixed setting in °C Non-adjustable
– Set by ID card
Blower Speed Blower speed in rpm -
Operator
Temp
PIM 'Operator Setpoint' dial setting in °C -
Temp Diff PIM hydronic fixed auto split differential in °C
Displays split value i.e. diff above and diff
below setpoint e.g. for diff of 12 will display 6
Flame Current Flame current in µA -
EMS VDC EMS input voltage in VDC Only if an EMS/BMS system is connected
Whilst in expanded boiler screen (shown above), tap on arrow on left side of screen.
PAGE 2
– Boiler Controls Screen. Items can only be adjusted if VERSA control board DIP switch 1 is ON (up)