In the case of SSB radios, the distance should be increased
to 7 ft (2 m).
– More than 2 m (7 ft) from the path of a radar beam. A radar
beam can normally be assumed to spread 20 degrees above
and below the radiating element.
• The product is supplied from a separate battery from that used
for engine start. This is important to prevent erratic behavior
and data loss which can occur if the engine start does not have
a separate battery.
• Raymarine specified cables are used.
• Cables are not cut or extended, unless doing so is detailed in
the installation manual.
Note: Where constraints on the installation prevent any of
the above recommendations
, always ensure the maximum
possible separation between different items of electrical
equipment, to provide the best conditions for EMC performance
throughout the installation
Suppression ferrites
Raymarine cables may be fitted with suppression ferrites. These
are important for correct EMC performance. If a ferrite has to be
removed for any purpose (e.g. installation or maintenance), it must
be replaced in the original position before the product is used.
Use only ferrites of the correct type, supplied by Raymarine
authorized dealers.
Connections to other equipment
Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment
using a cable not supplied by Raymarine, a suppression ferrite
MUST always be attached to the cable near the Raymarine unit.
Declaration
of
conformity
This
product
conforms
with
EU
Directive
2004/108/EC
and
is
labelled
with
the
CE
conformity
mark.
Product
disposal
Dispose
of
this
product
in
accordance
with
the
WEEE
Directive.
The
Waste
Electrical
and
Electronic
Equipment
(WEEE)
Directive
requires
the
recycling
of
waste
electrical
and
electronic
equipment.
Whilst
the
WEEE
Directive
does
not
apply
to
some
Raymarine
products,
we
support
its
policy
and
ask
you
to
be
aware
of
how
to
dispose
of
this
product.
Warranty
registration
It
is
important
that
you
register
your
product
to
receive
full
warranty
benefits.
Your
unit
package
includes
a
bar
code
label
indicating
the
serial
number
of
the
unit.
You
should
stick
this
label
to
the
warranty
registration
card.
Technical
accuracy
To
the
best
of
our
knowledge,
the
information
in
this
document
was
correct
at
the
time
it
was
produced.
However,
Raymarine
cannot
accept
liability
for
any
inaccuracies
or
omissions
it
may
contain.
In
addition,
our
policy
of
continuous
product
improvement
may
change
specifications
without
notice.
As
a
result,
Raymarine
cannot
accept
liability
for
any
differences
between
the
product
and
this
document.
Introduction
9
