Raymarine SmartPilot S1 Tiller Pilot, Руководство по вводу в эксплуатацию

Страница: 35 / 76

Chapter 2: Commissioning 23
Align the rudder position sensor
S1 WHEELPILOT ONLY
1. With the SmartPilot still in Dealer Calibration, press the
disp
key to scroll
through the calibration pages until you reach the
ALIGN RUD
page.
2. Center the rudder using the wheel.
3. Use the
1
and
+1
keys to adjust the rudder bar so it reads at center.
• the maximum adjustment available is ±9°. If the offset is beyond these
limits, you will need to physically adjust the alignment of the sensor.
4. Press
disp
to select the correct alignment and move to the next calibration
option.
Note:
Alternatively, you can zero the rudder bar with the boat underway during the initial
seatrial, by manually steering a straight course then accessing the
ALIGN RUD
screen
in Seatrial Calibration to adjust the offset.
Set the rudder limits
1. With the SmartPilot still in Dealer Calibration press the
disp
key to scroll
through the calibration pages until you reach the
RUD LIMIT
page.
2. Turn the wheel to move the rudder:
• to the port end stop and note the angle on the rudder bar
• to the starboard end stop and note the angle on the rudder bar
3. Use the
1, +1, 10
and
+10
keys to set the rudder limit to 5° less than the
lowest angle you have noted.
4. Press
disp
to select the new value and move to the next calibration option.
Save the new settings
When you have adjusted these basic settings in Dealer Calibration:
• press and hold
standby
for two seconds, your changes will be saved
• once saved, the controller will return to the
STANDBY
display
81282_1.book Page 23 Monday, October 2, 2006 1:58 PM