RAYCOM C
ELLULAR
(AMPS)
27
AMPS Technician Programming
AMPS Technician Programming Commands
The
RAYCOM Cellular (AMPS)
can be programmed on location with an ordi-
nary telephone, which is sometimes referred to as a POTS (Plain Old Telephone
Set) phone.
NOTE: the Technician Programming mode is not accessible
while in a call.
In the following sections, an
<entered value>
is comprised of the digits
0
through
9
. The digits '
*
' and '
#
' are considered invalid when used inside an
<entered value>
, and will cause that command/value to be rejected.
When you enter the programming mode, a timer is started. If there are no key
entries within any 2-minute period, the FWT will revert to its normal mode.
Going on-hook (hanging up the phone) will exit the programming mode.
How to Enter the Technician Programming Mode
Use the following access code to enter the Programming mode:
Press:
# * 0 * 1 2 3 4 4 3 2 1 #
The access code is
8
digits. If the access code is not 8 digits or does not match
the stored access code, the Technician Programming mode cannot be not
entered. This code is pre-programmed during production and cannot be
changed in the field.
If you enter the access code correctly, the dial tone should change to a differ-
ent, steady “Programming” tone and the LED indicator on the front of the
RAYCOM will blink alternately RED and GREEN to indicate that you’re in the
programming mode.
☞
IMPORTANT!
The following commands may be used by a trained service technician to
change the configuration of the
RAYCOM Cellular
. WARNING: these com-
mands are intended for use by trained service technicians only. Untrained
users could damage the Raycom, violate local regulations and breach the
service agreement with the cellular provider.
!
