RAYCOM C
ELLULAR
(AMPS)
15
INSTALLATION AND CONNECTION
your intended installation. For example, if the unit is being mounted vertically
on a bulkhead with the antenna jack pointing upwards, the bracket needs to
be installed with the slots pointing upward.
NOTE: If the lateral support mount is used, the slotted bracket must
be installed on the RAYCOM with the slots pointing in the same direc-
tion as the antenna jack. Otherwise the lateral mount can not provide
the required tension to keep the RAYCOM in place in rough seas.
8)
Remove the power, phone, and antenna
plugs if connected. Align the holes on the
mounting bracket with the two wall-mounted
screws and slide the unit onto the screws. If the
RAYCOM slides on easily, remove the unit and
tighten the wall-mounted screws slightly.
Repeat this procedure until it requires a mod-
erate amount of force to slide the unit onto the screws.
This will insure your RAYCOM stays securely in place.
Slide the unit off of the wall-mount screws.
9)
Reconnect the power and phone connections.
Insure they are routed through either the channel on
the bottom of the unit or out the slot adjacent to the
connector recess. Now slide the RAYCOM back onto
the wall-mount screws.
10)
If the unit is being mounted vertically, the lateral
support mount may not be necessary depending on
how much motion your vessel encounters. If horizontally mounted, the lateral
support is recommended for all installations. If the lateral support is required,
proceed to step 11. If not, reconnect the antenna connector and the installa-
tion is complete.
11)
Align the large hole of the lateral support bracket with the TNC antenna
jack and slide the bracket towards the unit until it makes contact and mark
the two holes for the mounting screws.
12)
Remove the bracket and drill the two holes for the hold-down screws.
Replace the lateral bracket over the TNC connector and install the bracket with
the two screws provided.
RAYCOM C
ELLULAR
(AMPS)
15
