• Use special (supplementary) cellular services which may be avail-
able in your cellular service area (see Special Cellular Services on
page 20).
How to Use the Hookflash Function
Depending upon your phone, there are two ways to initiate the Hookflash
function:
• Press the dedicated “HOOKFLASH” or “FLASH” key on your
telephone.
• Press the hang-up or switch-hook mechanism on your phone once
quickly (approximately 1/2-second).
Important Tones and Alerts
No-Service Tone –
When cellular service is not available, the receiver emits a
No-Service (fast-beeping) tone instead of the normal (steady) dial tone.
ROH (Receiver Off-Hook) Tone –
If the telephone equipment remains off-
hook (off its cradle) with no dialing activity for 45 seconds, the receiver emits
an ROH tone for 60 seconds.
Incoming Call Alert –
If you’re dialing a number and an incoming call occurs,
the receiver will emit an audible ring. To answer the incoming call:
• Press the “HOOKFLASH” button once. This will connect the incoming call.
• OR hang-up immediately. This will cause the phone to start ringing.
How to Adjust the Volume Level
If the volume level on your phone is too high or too low, you can adjust the
levels using the keypad on your telephone.
Note: your telephone must be
in Tone-Dial
(DTMF)
mode to adjust the levels.
To Increase Audio Level -
Increase the audio level in steps by pressing:
# * 8
(also known as
# * Up
)
Continue to press # * 8 until the desired level is reached.
To Decrease Audio Level -
Decrease the audio level in steps by pressing:
# * 3
(also known as # *
Down
)
Continue to press # * 3 until the desired level is reached.
NOTE: The default setting lets you adjust the audio up to three (3)
steps in either direction (Up or Down).
☞
☞
RAYCOM C
ELLULAR
(AMPS)
18
RAYCOM OPERATION
