RAYCOM C
ELLULAR
(AMPS)
17
RAYCOM Operation
Once your
RAYCOM Cellular
is installed and tested, it’s ready for operation.
How to Use the LED Status Indicator
1)
Apply power to the unit.
2)
As soon as power is applied, the LED status indicator will illumi-
nate. Wait approximately 10 seconds for the unit to initialize.
3)
The LED StatusTable below describes the modes and operation of
this 3-color indicator.
How to Place a Call
1)
Pick up your telephone handset (your phone is now “off-hook”).
2)
Listen for dial tone (If service is not available, a No-Service tone is
produced. Hang-up the phone and try again.)
3)
Dial the phone number.
How to Receive a Call
When your telephone rings, pick up the handset and begin talking.
How to End a Call
Hang-up the phone (place the handset back onto the telephone cradle).
Hookflash Function
When you initiate the Hookflash function, it automatically lets you:
Speed up the connection after you dial a phone number.
• Answer an incoming call that occurs when you’re dialing a
phone number.
LED Status Table
LED Color
LED Activity
Description
RED
Flashing
Malfunction. Hardware fault detected.
RED
Continuous
No cellular service.
YELLOW
Continuous
Moderate cellular signal strength.
GREEN
Continuous
Best cellular signal strength.
RED/GREEN
Flashing
Diagnostic/programming mode.
OFF
None
No Power.
