Raymarine Quantum Radome, Руководство по установке

Страница: 35 / 54

6. Ensuring that the bolts have a minimum insertion
in the scanner base of 16mm (0.63 in.), and
a
maximum of 22mm(0.87in.) (allowing for
washers), secure the scanner with the 4 bolts,
flat washers and spring washers provided, as
illustrated. If necessary, use appropriate shims or
extra washers to limit the length of bolt entering
the scanner base.
7. Tighten the bolts to a torque of 15Nm(133ftlbf).
8. Attach a safety lanyard (not supplied) to your
vessel, and secure the free end to the scanner
using the attachment point shown in the following
illustration:
Item Description
1 Safety lanyard attachment point.
Note: If you are installing the Radar scanner on a
sailing vessel, additional protection for the Radar
scanner may be required. Refer to
6.3 Radar
scanner protection — sailing vessels .
Multiple Quantum Radar scanners
Only 1 (one) Quantum ™ Radar scanner can be used
at any one time, per networked system.
If you have more than one Quantum ™ Radar scanner
installed on your vessel and want to use them at the
same time, the multifunction displays to which the
scanners are connected must NOT be networked
together. This applies to Quantum
™ scanners
connected either wired or wirelessly.
For more information, refer to: Multiple Quantum
Radars — more information .
Multiple Radar scanners — location
requirements
Important location considerations when installing
multiple radar scanners on the same vessel.
• Scanners should be mounted above each other,
vertically separated by at least 0.5m (1.6ft). This
applies to all installation locations on the vessel.
• Multiple scanners should be mounted in a way
that minimizes interference between the vertical
beamwidths of the 2 scanners.
• In all cases, you should aim to achieve as much
physical separation as possible, to minimize any
potential interference.
Mounting
41