Raymarine Quantum Radome, Руководство по установке

Страница: 34 / 54

6.1 Mounting pre-requisite:
"breather" holes
The base of the unit features a "breather", a series of
small holes which allow air to circulate between the
underside of the unit and the mounting surface.
1. Location of “breather” holes.
Ensure that the breather is not blocked in any way.
Examples of obstacles to airflow include sealant and
paint.
If necessary, use additional washers to allow a
small gap between the underside of the unit and the
mounting surface, for airflow.
6.2 Mounting the scanner
Use a mounting location that:
• Is robust enough to support the Quantum ™
scanner, under seagoing conditions.
• Meets the requirements described under Scanner
Position .
Then:
1. Tape the template to the mounting platform,
ensuring that the arrow on the template is pointed
towards the front of the vessel.
2. Drill 3mm pilot holes in the four positions shown
on the template.
3. Drill out the pilot holes to 10mm diameter.
4. Place the Quantum
™ scanner in position. If you
are fitting it on a planing vessel, shim the rear
of the scanner, so that the beam points slightly
down in the forward direction when the boat is at
rest, to compensate for the bow rising at cruising
speed
Item Description
1
Mounting platform, non-planing boat (level install)
2 Mounting platform, planing boat (typical planing
angle shown)
5. Before securing the scanner to the mounting
platform, connect the power cable (and optionally
a data cable), ensuring that all cables are
routed appropriately. See the
4.3 Connections
overview section for further information about
making connections, and cable routing.
40