Item
Description
Limits
Reverse
rudder ref
This reverses the phase of the
rudder reference display.
Note:
This option is
not available on SeaTalk
systems, so you would need
to reverse the RED and
GREEN wires on the Rudder
Reference connection to the
course computer.
• Port
• Starboard
Item
Description
Limits
Auto trim
The AutoTrim setting
determines the rate at which
the SmartPilot system applies
‘standing helm’ to correct for
trim changes caused by varying
wind loads on the sails or
superstructure. The default
AutoTrim is set as part of the
Autolearn process.
If you need to change the
setting, increase the AutoTrim
one level at a time and use the
lowest acceptable value:
• If the SmartPilot X system
gives unstable course
keeping or excessive drive
activity with a change in the
heel angle, decrease the
AutoTrim level.
•
If the SmartPilot X system
reacts slowly to a heading
change due to a change in
the heel angle, increase the
AutoTrim level.
•
If the AutoTrim level is too
high, the vessel will be less
stable and snake around the
desired course.
Setting
• Off
• On
Adjustment
• 1 — 4 1 = Slowest, 4 =
Fastest
• 1 (default)
Adjust settings
51
Содержание P70
