Raymarine P70, Руководство по установке

Страница: 42 / 80

5.6 Dealer settings
The dockside calibration wizard is only available on a SeaTalk ng
system, for SeaTalk systems the Dealer settings should be set
before going out on the sea.
The dealer settings menu can be accessed from: Main menu > Set
up > Auto pilot calibration > Dealer settings . Once entered the
dealer settings menu will cycle through all available options.
Options and limits are dependent on the course computer installed.
5.7 Seatrial calibration
Once dockside calibration has been completed (Dealer settings for
SeaTalk systems), navigate to a place where you have plenty of sea
room, then carry out the seatrial calibration procedures to complete
the SmartPilot system commissioning.
Seatrial calibration contains the following steps:
• Compass calibration.
• Autolearn.
You can access the Seatrial calibration menu at any time
from the following
Menu > Set up > Auto pilot calibration >
Commissioning .
Note: Sailing vessels should perform the sea trial under engine
power.
Warning: Seatrial calibration
Ensure you have sufficient sea room for calibration.
The seatrial calibration maneuvers require a clear,
familiar area of water. Ensure you are not likely to
collide with any vessel or other obstruction during
calibration.
Warning: Maintain sensible speeds
The autopilot may make unexpected turns.
Calibrating the compass
Before you can use your autopilot you need to do some open water
checks. The water must be calm, with light or no wind. Leave plenty
of room to maneuver.
1. Using the
UP and DOWN buttons, or the ROTARY controller,
highlight Seatrial calibration and press CONTINUE .
42
p70 / p70r Pilot controller Installation instructions