Raymarine P70, Руководство по установке

Страница: 40 / 80

5.5 Dockside calibration
Dockside calibration (Dealer settings on SeaTalk systems) must
be completed before going out on the water and performing the
sea trial calibration
Dockside calibration contains the following steps:
• Drive type selection
• Rudder check
• Motor check
You can access the dockside calibration menu at any time
from the following
Menu > Set up > Auto pilot calibration >
Commissioning .
Note: You will need to measure the hard over time of you rudder
prior to commencing dockside calibration.
Selecting a drive type
1. Using the UP and DOWN buttons or the ROTARY highlight
Dockside calibration and press SELECT .
2. From the Drive type menu highlight and select your drive type:
Note: If your drive type is not listed, contact your Raymarine
dealer for advice.
3. Press OK to save your setting and display the next set up page.
This is either:
• The Rudder check (center) page, if the vessel has a rudder
reference transducer, or
• The Motor phasing non-referenced page, if a rudder
reference transducer is not fitted.
4. Press OK to proceed with the Rudder and motor checks.
You can cancel Dockside calibration at any time by pressing
STANDBY .
Warning: Rudder check
If no rudder reference has been fitted you MUST
ensure that adequate provision is made to prevent the
steering mechanism from impacting the end stops.
Checking the rudder
This procedure establishes port and starboard rudder limits
for systems using a rudder reference transducer. Fine-tuning
adjustments to the rudder position may be made during seatrial
calibration.
Note: Systems without a rudder reference will go straight to
motor checks.
1. Centre the rudder and press OK .
2. When prompted, turn the rudder hard to port and press OK .
3. When prompted, turn the rudder hard to starboard and press OK .
4. When prompted, turn the rudder back to centre and press OK .
5. If a rudder reference is installed the rudder limit will be displayed
with a message letting you know the rudder limit has been
updated.
You can cancel Dockside calibration at any time by pressing
STANDBY .
Checking the motor (motor phasing checks)
The system will check the drive connection from the SmartPilot.
Once it has completed the check successfully, a message will
appear asking if it is safe for the system to take the helm.
Note: For systems with a rudder reference transducer installed
this check shall follow the rudder checking, for systems without a
rudder reference this step shall follow the drive type selection.
1. Centre and let go of the rudder.
40
p70 / p70r Pilot controller Installation instructions