4.3 Mounting the unit
The unit is mounted using the bracket provided.
Before mounting ensure that you have:
• selected a suitable location.
• installed the transducer and routed the
power/transducer cable to the selected location.
1
2
D13191-1
3
4
D13192-1
1. Slide the Hex (allen) bolt through the pivot ball,
then slide the pivot ball through the center of the
bracket locking collar.
2. Using a 5 mm Hex (allen) key (not supplied),
screw the Hex (allen) bolt into the underside of
the unit, ensuring the locating tabs are correctly
aligned.
3. Using the fixings provided mount the bracket
base to the mounting surface as follows:
i.
Mark the location of the bracket base’s
mounting holes on the chosen mounting
surface.
ii. Drill holes for the fixings using a suitable drill,
ensuring there is nothing behind the surface
that may be damaged.
iii. Use a pozi-drive screw driver and an 8 mm
wrench (spanner) to attach the bracket base
securely to the mounting surface using the
fixings provided.
4. Position the unit at the desired angle and secure
by tightening the locking collar.
The unit can be removed from the bracket, by
unscrewing the locking collar.
Dragonfly-7 Pro mounting using RAM
®
mounts
The
Dragonfly-7 Pro
can also be bracket mounted
using
RAM
®
mounts compatible with the RAM 1”
Tough-Ball
™
with M6–1 x 6mm Male threaded post
(Part Number: RAP-B-379U-M616).
D13472-1
The threaded post can be attached to the M6 captive
nut, located top center on the rear of the display.
Mounting
31
