Raymar Alliance V.32, Инструкция по эксплуатации

Страница: 74 / 201

0049-2702-XXX Alliance Series Modems – USER MANUAL 08/05/2010
Rev. A Page 70 of 197
How to Store a Phone Number
This section explains how to store phone numbers using the modem’s front panel controls. To
store numbers using the DTE keyboard, in Hayes and V.25bis modes, see Chapter 4 (Hayes
mode) and 5 (V.25bis mode).
To store a phone number using the modem’s front panel controls, follow these steps:
1. Select PHONE from SETUP screen 5. The ALX will display this screen:
2. Specify the phone cell (i.e., memory storage location) where you want to store the
number:
Use DEC (pushbutton 1) or INC (pushbutton 3) to cycle through the two-digit
phone cell numbers (0-49), which appear in the upper right corner of the screen.
You may store a number in an empty cell, which is indicated by the letter “e” to the left of the
storage cell number, or you may change (edit) a previously stored number. (A # symbol next
to a cell number indicates that a number is stored in the cell.)
3. Select PROG (program) from the PHONE CELL: screen. The LCD will display this
screen:
If a number has been previously stored, the number will be displayed on the top line of the
LCD (instead of dashes, as shown above).
4. Enter the number to be stored by using the front panel pushbuttons as follows:
•
Use the right and left arrow pushbuttons to place the LCD cursor in the cell
(i.e., character space) where you want to enter or change a number or character.
The cell or character where the LCD cursor is located flashes on and off.
•
Use pushbutton 1 to decrease a number at the current cursor location or
pushbutton 3 to increase a number.
•
Use pushbutton 2 (CTRL) to cycle through the dialing modifiers. The dialing
modifiers are listed in Table 4-2. Dialing modifiers can be saved with a phone
number to perform the functions listed in Table 4-2 when the number is dialed.