Raymar Alliance V.32, Инструкция по эксплуатации

Страница: 199 / 201

0049-2702-XXX Alliance Series Modems – USER MANUAL 08/05/2010
Rev. A Page 195 of 197
Before installing this equipment, users should ensure that it is permissible for connection to the
facilities of the local telecommunications company. The equipment must be installed using an
acceptable method of connection. In some cases, the company’s inside wiring associated with a
single line individual service may be extended by means of a certified connector assembly
(telephone extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request the user to
disconnect the equipment.
Users should ensure, for their protection, that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections themselves, but should contact
the appropriate electrical inspection authority or electrician, as appropriate.
The load number (LN) assigned to each terminal device denotes the percentage of the total load
that can be connected to a telephone loop which is used by the device, in order to prevent
overloading. The termination on a loop may consist of any combination of devices subject only
to the requirement that the total of the load numbers of all the devices does not exceed 100. An
alphabetic suffix may be used to specify the ringing type (A or B), if applicable. The
load
number for the Alliance Series modem is 6.