Raymar Alliance V.32, Инструкция по эксплуатации

Страница: 120 / 201

0049-2702-XXX Alliance Series Modems – USER MANUAL 08/05/2010
Rev. A Page 116 of 197
For pulse dialing, digits 0 through 9 can be stored; for tone dialing, 0 through 9, A through D, #
and * can be stored. The dialing modifiers listed in Table 4-2 can also be stored.
Fifty phone cells are available: 0-49.
Each phone cell can hold up to 50 characters,
maximum . For any given cell, this limit may be lower, depending on how other phone cells are
loaded relative to total available storage memory. For details, see Chapter 3. You will get an
ERROR message if you attempt to save a dial string of more than 50 characters or if the
available memory becomes full.
To delete a stored phone number, enter
AT &Zc= , where c is the phone cell number (or use &Z
to overwrite a new phone number over the old one).
\S – View status of V.42-related configuration The \S command displays the active V.42 error
correction configuration, stored V.42 profiles, and certain other data not displayed by the &V
command.
S-REGISTERS
The ALX modem includes S registers that can be used to control specific modem operations.
Each register holds a value that serves as a specific operating instruction for the modem. Several
of the S registers affect how the previously described commands will be executed.
The functions of the registers intended for user access are explained below and summarized in
Table 4-4.
Reading and Setting Registers
An alternate way to change S registers is explained in Appendix C .
Use the
S command to read the value of a register or to change its value.
To read the current value of a register, use the command
S? , where the number of the register is
specified between the S and the ? , as follows: S9? . The decimal value of the register contents
will then be displayed. Multiple registers may be read. For example, if you wish to read the
current value in registers S0 and S7, enter
AT S0? S7?