Rayleigh Instruments RI-ENERGYFLOW-MODULAR Series, Руководство пользователя

Страница: 38 / 52

Menu Path: Setup > Enter Password (Default 00000) > SYS Setting: (CONTINUED)
Menu Path: Setup > Enter Password (Default 00000) > BAT Setting
Menu Path: Setup > Enter Password (Default 00000) > SYS Setting: (CONTINUED)
DOD Enable Enable
Depth of discharge. This should always be enabled.
Disabling will result in the battery discharging to 0%
Generator Disable
This option allows the user to install a secondary means
of generation. For example, wind generator or diesel
CT option is used for measuring the system current
Meter
Estron
Acrel
Rayleigh
Meter option is used for measuring the system current
AC Couple Disable
Allows the user to connect an external inverter to the
system (either instead of PV, or in-addition to PC -
CT Direction Positive Reverses the direction of current flow measurment
ISLAND Enable
When enabled, the inverter will continue to export
power via the BACKUP port in the event grid
SYS
Setting
CT or METER CT
Disable
Enable
Positive
Negative
Disable
Enable
Disable
Enable
Disable
Enable
CT
BAT Type RI-MOD 5.1
Shows the user what type of battery is connected to the
system
DISC Depth 90%
Sets the maximum depth of discharge during grid
connected state
OFFGRID
DOD
90% Sets the maximum depth of discharge when off-grid
CHG CURR 60A Sets the maximum battery charge current
DISC Power 80% Sets the maximum discharge power - % of rated output
CHG Power 100% Sets the maximum charge power - % of rated output
BAT End Volt 43.2V Sets the voltage that is seen as 0% remaining
If enabled the battery will contantly monitor state of
charge and depth of discharge. If time option is selected,
the battery will wake up and check the state of charge
and depth of discharge at the interval set
Time Set time
If time is selected the user will be prompted to enter a
value 0…300 minutes
Heating FLIM Automatic
Allows the user to enable or disable the heating film
installed within the battery modules. Automatic means
the system measures the Outside temperature and turns
the film on as needed. Only applicable if heating film is
requested at time of ordering
BMS DOD Disable
Leave disabled. The inverter will monitor depth of
discharge.
Maintain SOC Enable
Disable: The minimum SOC will not be maintained.
Enable: The minimum SOC 2% is maintained. When
the battery SOC is less than 2%, the grid charges the
battery pack to 5% through the inverter.
Force Wake Disable
Enabling this option means the battery will always
remain online and will not go to sleep
Enable
BAT Setting
BAT Wake-up
0…100%
0…48V
Enable
Automatic
ON
OFF
Lead Acid
RI-MOD 5.1
0…100A
0…100%
0...100%
0…100%
Disable
Enable
Disable
Enable
Disable
Enable
Page 38