Rayburn Two-Oven, Инструкция по использованию, установке и обслуживанию

Страница: 20 / 24

20
SERVICING INSTRUCTIONS
REPLACING PARTS
2.6 • Remove the three screws (Arrow B) and the fan motor
from the panel, Diagram 4.
2.7 • Replace the fan motor and reassemble in reverse order
3.1 There are two overheat switches located on the rear of
the fan oven assembly panel.
To replace either of these switches, follow steps 2.1 to 2.4
above:
• Remove the two fixing screws from the defective switch
identified, Diagram 5
3.2 • Replace the overheat switch and reassemble in reverse
order ensuring no wires are trapped when replacing the
fan
3.3 There is also an overheat switch on the Lower Oven
element. To access this follow Section 6
4.1 • Open the Fan Oven door and loosen the four screws
holding the fan cover
• Lift the fan cover of the screws, Diagram 6
4.2 Remove the three screws retaining the oven element and
carefully pull forward the element to expose the
connections. See diagram 7, Arrow C.
4.3 • Disconnect the wires making sure they do not fall
behind the oven.
4.4 • Replace the element and reassemble in reverse order.
5.1 Remove the single screw from the rear of the element
and the two screws retaining the support bracket.
See diagram 8.
5.2 Carefully pull the element forward to expose the
connections and disconnect the wires making sure they
do not fall behind the oven.
5.3 Replace the element and reassemble in reverse order.6.
6.1 There are two elements in the Lower Oven:
• One in the top of the oven
• One under the loose plate of the bottom
5
7
6
8
3. OVERHEAT SWITCHES
5. GRILL ELEMENT
6. LOWER OVEN ELEMENT
4. FAN OVEN ELEMENT
AR1592
AR1557
AR1587
AR1587
C
C
C