King Kong of Skull Island
™
14 |
P a g e
6.
Lower the door on the spacer cabinet and install the spacer screws through the mating holes in the
top of the door and tighten.
Joining the Four Cabinets Together
1.
Make sure all cables, harnesses, and air lines are connected, and push the cabinets together so there
is minimal space between each one.
Take care to ensure that all cables, harnesses, and air lines are
not pinched between the cabinets when joining.
2.
Lay the right joiner beam down on the floor next to the game assembly and plug the LED light
connector into the mating connector on the lower side of the front cabinet.
3.
Hang the joiner beam onto the top edge of the cabinets and begin starting to thread the screws into
the aligning holes and slots in the sides of all four cabinets (
fig. k,
below). It is recommended that you
start at the motion base and work your way outwards. The cabinets should begin to straighten and
align as you tighten the screws, but do not begin the final tightening of the screws until all beam
screws are threaded.
4.
Repeat steps 2-3 for the left joiner beam.
5.
Once all of the beam screws are tightened, position the game in the desired location and lower the
leg levelers to lock the game into position (
fig. l,
below). Be sure the jam nuts are screwed upward
and tightened up to the leveler plate weld nut to prevent the leveler from disengaging the floor.
fig. k
fig. l
NOTE: If the cabinet ever needs to be moved, please follow the above assembly steps in reverse order.
