Pagina 18 di 33
RAVENNA s n c - OFFICINE METALMECCANICHE RIMORCHIO PER TRATTORE
4.3 ATTACHMENT TO A TRACTOR
First of all check that the tractor’s attachment system is approved. To attach the trailer to
the tractor, approach it with appropriate maneuvers in such a way that the coupling on the
tractor and the towing eye on the drawbar of the trailer are located very close. Perform the
operation by moving the tractor and avoiding the manual maneuvers.
Photo 2
Raise the trailer drawbar, turning the hand wheel N, the height of the hook of the tractor,
pull the coupling pin after removing the cotter pin from it, then take it with the eye of the
trailer, put the pin in eye and insert the cotter pin in the pin.
Perform the above steps carefully: on the rudder there are vertical forces that may act make
it difficult to control!
Using the hand wheel N raise from the ground as much as possible the wheel: in this way
the trailer rests on the rear axle on the one hand and on the coupling on the tractor other.
The wheel can be further raised from the ground, turning it upwards: the spring P (Photo 3)
holds it in this position: pulling the retaining pin Q the wheel, if necessary, can also be
removed from the trailer.
N
O
R
S
T
