Ravenheat HE Primary AAA, Инструкция по использованию, установке и обслуживанию

Страница: 17 / 47

Supplied By www.heating spares.co Tel. 0161 620 6677
18
5.4 POSITIONING OF THE BOILER
5.41 Remove the 4 screws that secure the upper
and the lower part of the casing(Fig.19-20).
5.4.2 Unscrew the 4 screws that fasten the lower
grating on the casing and remove it from the
sides of the casing (Fig.20)
5.4.2.1 Carefully slide the casing forward to lift off.
(Fig 21).
5.4.2.2 Make sure that the casing and screws are put
to one side in a safe place.
5.4.3 Lifting instrument panel (not necessary
for installation).
- Unscrew the 2 screws that fasten the
instrument panel.
- Lift the instrument panel in order to
deta ch it from the sides, and lift it up
by rotating it on its own hinges.
Make sure the casing screws are put to
one side in a safe place.
Fig. 19
Fig. 20
Fig. 21
Fig. 28
IMPORTANT: Make sure that the elbow’s dia 60 mm
duct is inserted into the fan, the rubber seal and orifi ce
(F2) have been cor rectly fi tted.
5.5 INSTALLING THE APPLIANCE FOR
REAR FLUE OUTLET
5.5.1 Use adhesive tape to attach the template to the
wall, making sure that the centre line is vertical
- Mark the four boiler fastening holes on the
wall as well as the centre of the fl ue duct
- Detach the template from the wall.
- Use a 10 mm dia drill to make the 4 boi ler
securing holes Insert the plastic expansion
plugs.
- Cut or core drill a 105 mm dia hole for
inserting the fl ue duct
- Screw in the two upper coach bolts leaving
them about 10 mm out from the wall to
enable the boiler to be located on the wall .
Fit the elbow header positioning it towards
the required direction (Fig 30).