Raven Sidekick Pro, Инструкция по установке и эксплуатации

Страница: 72 / 98

C
HAPTER
5
70 CAN Sidekick Pro Injection for Case IH 3/4XXX Installation and Operation Manual
6. Touch the Calibrate Pump button to initiate pump calibration. The pump will proceed to run until the console
detects 1 oz. [0.3 dL] of chemical has been passed through the pump and the console displays a “calibration
complete” message.
NOTE: If the console displays an error message during the priming process, verify that the conditions listed
in step 4 are present. If the problem continues, see Chapter 7, Troubleshooting, to resolve issues
during the pump calibration process.
7. Check the calibrator plunger on the injection pump. The black ring on the plunger should stop within the
“window” markings on the calibrator cover if the pump calibration is successful. If the black ring stops slightly
outside of the calibration window, the meter cal value may be adjusted to compensate:
•
If the plunger stops below the calibration window, increase the meter cal.
•
If the plunger stops above the calibration window, decrease the meter cal.
FIGURE 5. Install Cover
NOTE: The initial meter cal should be adjusted in increments of 1% from the default meter cal. If the meter
cal must be increased or decreased by more than 5% from the value printed on the pump housing,
perform pump maintenance procedures outlined in the Sidekick Pro Calibration and Operation
Manual. If the problem persists, troubleshoot the injection system, for possible solutions to issues with
the injection pump.
Plunger
Calibration
Window