Raven Sidekick Pro ISO, Руководство по установке и эксплуатации

Страница: 66 / 82

C
HAPTER
7
62 Sidekick Pro™ ISO Installation & Operation Manual
PUMP CAM AND BEARING
Chemicals may seep into the bearing cavity. The pump cam and bearing housing should be cleaned and inspected
periodically to prevent maintenance issues.
1. Loosen the four socket head screws holding the pump head to the motor assembly.
2. Remove pump from motor and clean surfaces of cam and bearing.
3. Examine the sealed bearing. If the bearing does not turn freely or smoothly, replace the bearing.
4. Apply a heavy coating of automotive grease to the area where the piston engages the cam bearing and
reassemble pump to motor.
PISTON SEAL REPLACEMENT
The piston seals within the injection pump motor housing should be replaced periodically to keep chemical from
seeping into the pump housing. The piston seals should be serviced or replaced if chemical begins leaking from
the weep hole on the underside of the pump housing.
NOTE: New piston seals are supplied in the Pump Seal Kit (P/N 117-0159-987) available through a local Raven
dealer. A complete replacement pump kid (063-0172-924) is available through a local raven dealer.
FIGURE 2. Pump Head and Motor Separation (D/N 016-0171-134)
CAUTION
Chemical residue or build up may be present on
internal pump components. Wear gloves when
servicing internal pump assemblies.
CAUTION
Chemical residue or build up may be present on
internal pump components. Wear gloves when
servicing internal pump assemblies.