Raven Sidekick Pro ISO, Руководство по установке и эксплуатации

Страница: 19 / 82

3
P/N 016-0171-509 Rev. E 15
INSTALLATION
FIGURE 3. Point of Injection Detail
To set up the point of injection:
1. Select the point of injection.
2. Install a carrier check valve or a mixer assembly in the main product line to prevent back flow to the carrier
reservoir. Refer to Table 1, “Check Valve Sizing and Selection Chart,” on page 16 proper sizing of the carrier
check valve or see Figure 4 on page 15 for details on available mixer assemblies.
3. Install tee type fitting, or fittings, suitable for chemical applications after the carrier check valve as needed. Tee
fittings may be installed in mixer assemblies to provide inlets for additional injection systems.
4. Install an in-line mixer to the through port of the tee fitting and connect to the existing carrier product line or
boom valve manifold. Use Figure 5 on page 17 to determine proper sizing of the in-line mixer. Use Table 1,
“Check Valve Sizing and Selection Chart,” on page 16 to determine proper sizing of the carrier check valve.
5. Install a Raven 12 PSI chemical injection check valve (P/N 333-0011-102) to the injection line in front of the point
of injection to prevent back flow to the chemical reservoir.
NOTE: It is important to flush the check valve periodically and when changing chemicals to preserve proper
operation.
FIGURE 4. Check Valves and In-Line Mixer
NOTE: Be sure to install the check valves with the flow direction indicator pointing in the direction of
chemical flow.
From Carrier
Product Tank
To Boom
Valve
Manifold
From
Injection
Module
Injection
Point Check
Valve
In-Line Mixer
Point of
Injection
Carrier
Check Valve
Inlet
Outlet
Inlet
Outlet
Carrier Check Valve
Injection Point Check
Valve
Inlet
Outlet
Recirculation/Priming Check Valve
Stainless Steal Mixer Assembly
Inlet
Identifier
Identifier
046
102
Outlet