Raven Sidekick Pro ISO, Руководство по установке и эксплуатации

Страница: 18 / 82

C
HAPTER
3
14 Sidekick Pro™ ISO Installation & Operation Manual
INITIAL PLUMBING AND POINT OF INJECTION
• The Raven Sidekick Pro™ ISO injection system pumps chemical into the main carrier line at the point of
injection. This point must be on the pressure side of the carrier product pump and should be as close to the
boom section valves as possible.
• It is not necessary for injected products or chemicals to be measured by the flow meter. Depending upon the
type of applications or chemical mixtures the injection system will normally be used with, it may be more
desirable to place the injection point after the flow meter. This configuration may help to extend the service life
of the flow meter by minimizing exposure to corrosive chemicals to the flow meter components.
• Check valves should be used in both the carrier and injection lines to prevent back flow and contamination of
carrier and chemical reservoirs.
• An in-line mixer should be installed after the point of injection to ensure even mixing of the injected product.
• The following options are available for setting up the point of injection:
•
An in-line mixer assembly with a carrier check valve included. This option requires use of a separate
injection check valve for each injected chemical.
•
Separate point of injection check valve, point of injection tee, and mixer fittings for each injected
product. Additional tee fittings may be required for additional injection products and a separate
injection check valve is required for each injected chemical.
FIGURE 2. Basic Sprayer Plumbing Diagram with Added Injection System