Raven Sidekick Pro ISO, Руководство по установке и эксплуатации

Страница: 6 / 82

C
HAPTER
1
2 Sidekick Pro™ ISO Installation & Operation Manual
• Seek medical attention immediately if illness occurs during or shortly after the use of chemicals.
• Fill, flush, calibrate, and decontaminate sprayer systems in an area where runoff will not reach ponds, lakes,
streams, livestock areas, gardens, or populated areas. Thoroughly flush or rinse equipment used to mix,
transfer, and apply chemicals after use.
• Before servicing any component of the system, thoroughly flush or rinse components with water.
• Improper disposal of waste may threaten the environment and ecology. Dispose of empty containers properly.
Triple-rinse empty containers and puncture or crush when disposing. Contact a local environmental or
recycling center for additional information.
If the system malfunctions or becomes clogged, stop the engine or pump and relieve pressure from the spraying
system before servicing.
Do not operate machinery without instruction and keep equipment in proper working condition. Unauthorized
modification to equipment may impair machine function and/or safety and may shorten the working life of
equipment.
Wear clothing appropriate for the job being performed and avoid loose fitting clothing while working on or near
moving components. Keep long hair away from moving components.
INSTRUCTIONS FOR WIRE ROUTING
The word “harness” is used to mean all electrical leads and cables, bundled and unbundled. When installing
harness, secure it at least every 30 cm (12in) to the frame. Follow existing harness as much as possible and use
these guidelines:
Harness should not contact or be attached to:
• Lines and hoses with high vibration forces or pressure spikes
• Lines and hoses carrying hot fluids beyond harness component specifications
Avoid contact with any sharp edge or abrading surfaces such as, but not limited to:
• Sheared or flame cut edges
• Edges of machined surfaces
• Fastener threads or cap screw heads
• Ends of adjustable hose clamps
• Wire exiting conduit without protection, either ends or side of conduit
• Hose and tube fittings
Routing should not allow harnesses to:
• Hang below the unit
• Have the potential to become damaged due to exposure to the exterior environment. (i.e. tree limbs, debris,
attachments)
• Be placed in areas of or in contact with machine components which develop temperatures higher than the
temperature rating of harness components
• Wiring should be protected or shielded if it needs to route near hot temperatures beyond harness component
specifications
CAUTION