18
2.
OTHER DISPLAY FEATURES
1)
To display TOTAL AREA covered, momentarily depress .
To "zero out" this total at any time, enter a "0" in this key.
2)
To display TOTAL VOLUME sprayed, momentarily depress
.
To "zero out" this total at any time, enter a "0" in this key.
3)
To display FIELD AREA covered, momentarily depress .
To "zero out" this total at any time, enter a "0" in this key.
4)
To display FIELD VOLUME sprayed, momentarily depress .
To "zero out" this total at any time, enter a "0" in this key.
5)
To display DISTANCE (feet) [meters] traveled, momentarily depress . To "zero out" this total
at any time, enter a "0" in this key.
6)
To display SPEED, momentarily depress
.
7)
To display VOL/MIN, momentarily depress .
8)
To display AREA/HOUR, momentarily depress
. This is an actual calculation of
AREA/HOUR at the present speed you are going. It is not an average over a period of time.
9)
To display US, SI, or TU; SP1 or SP2; and C-SD, C-F, C-FC, C-P or C-PC after being selected,
depress
.
3.
SELF TEST FEATURE
SELF-TEST allows speed simulation for testing the system while vehicle is not moving. Enter the
simulated operating speed in . If 6 MPH [10 km/h] is desired, enter 6.0 [10.0]. Verify SPEED
by depressing . The SELF-TEST speed will clear itself when motion of vehicle is detected
by the Speed Sensor. A SPEED CAL value of 900 [230] or greater is recommended when operating
in this mode.
NOTE:
To prevent nuisance clearing of self-test speed, disconnect speed connector on
back of Console when Radar Speed Sensors are used.
Содержание SCS 460
Страница 1: ...SCS 460 3 TIER DRIVER INSTALLATION AND SERVICE MANUAL...
Страница 3: ......
Страница 5: ...Manual Rev A SCS 460 3 Tier Driver 02 02 016 0159 888...