PAGE 24/36 |
Installation manual
|
016-8000-028EN
|
Rev. B
Raven Industries Inc.
CRX/ ROS INSTALLATION | CRX/VIPER 4+ ROS - RS1 | RAVEN EUROPE GENERIC
14.
Remove the sensor disc from the strip. Then
mount the sensor disc again to the strip with
the aid of M5 X 30 bolts, raised with two nuts
and two washers on each side. Mount on the
correct side of the strip (Figure 25) and pay
attention to the orientation of the disc (Figure
26). The triangular marker must be on the
correct side.
Make sure the the two nuts and
washer are installed underneath the disc.
15.
Make sure the sensor magnet (Figure 26) in the
sensor disc is completely clean (no iron fillings)
before being mounted. Clean the sensor
magnet with compressed air if necessary
(Figure 27). Mount the strip back on the front
axle.
16.
Check again if the sensor disc lies under slight
pretention against the sensor housing (Figure
28). Push with your thumb to the end of the
wheel angle sensor strip to check this. The
sensor disc may only have a little bit of friction
in the sensor housing. The sensor disc should
bounce back easily and without friction (Figure
29).
Caution!:
The sensor disc should be in a fully centered
position within the sensor housing. The strip
should be able to flex in a downward direction.
FIGURE 26 DIRTY WHEEL ANGLE SENSOR MAGNET
FIGURE 27 CLEANING WHEEL ANGLE SENSOR
MAGNET.
FIGURE 25 WHEEL ANGLE SENSOR DISC MOUNTED
WITH SPACERS