Rauch AXIS ISOBUS, Инструкция по эксплуатации, Страница: 90 / 110

Spreading operation with the machine control unit AXIS ISOBUS 5
84
5.5 Automatic mode with static weighing (AUTO km/h + Stat. kg)
The AUTO km/h + Stat. kg operating mode is to be used for smaller spreading
volumes or for working on hillside terrain EXCLUSIVELY .
1. Switch on the AXIS ISOBUS.
2. Open the Weighing trip counter > Weigh quantity menu.
3. Weigh fertiliser quantity via Refill or New fertiliser .
Refer to chapter 4.10.3: Weigh quantity (weighing spreaders only), Page 64 .
4. Configure the fertiliser settings:

Application rate (kg/ha)

Working width (m)
5. Insert fertiliser.
 The Weigh quantity window is displayed.
6. Select the desired type of filling:
Refill : Continue spreading with the same fertiliser. All saved values (flow fac-
tor) are retained.
New fertiliser : The flow factor is reset to 1.0. If necessary, the required flow
factor value can be entered subsequently.
7. Determine the flow factor from the provided fertiliser chart or according to em-
pirical values.
8. Enter the flow factor manually.
9. Press Start/Stop .
 The spreading starts.
10. After at least 150 kg of fertiliser spread, press the Start/Stop key.
11. Stop the tractor on a plain surface.
The machine must be horizontal.
12. Open the Weighing trip counter > Weigh quantity menu.
13. Select the Weigh remaining quantity selection field.
 The software compares the spread quantity with the actual residual quan-
tity in the hopper.
 The software recalculates the flow factor.
14. Define the flow factor.
Press
Confirm flow factor in order to apply the newly calculated flow factor.
Press the ESC key in order to apply the previously saved flow factor.
NOTICE
To change the fertiliser settings while driving (e.g. to the field), open the Weigh
quantity menu in standstill before spreading.