Ransburg 80100 Series, Руководство по обслуживанию

Страница: 12 / 60

9060 High Voltage Controller - Introduction
7 CP-13-05.3
INTRODUCTION
GENERAL DESCRIPTION
The
Ransburg 9060 High Voltage Control-
ler (80100-XXX) is used to provide high
voltage for electrostatic application equipment.
It uses a combination of proven high voltage
generation technology and microprocessor-
based control. It uses a variable voltage
output to drive a cascade that amplifies the
voltage to a high kV level. It also uses
current feedback information to maintain the
desired set point. The processor circuitry
provides the maximum in applicator transfer
efficiency, while maintaining the maximum
safety.
The 9060 Controller can operate in either
LOCAL mode or REMOTE mode conditions.
In the LOCAL mode, the selection and adjust-
ment of set point values is performed from the
controller front panel. The triggering of the HV
in LOCAL mode is initiated by the optional
airflow switch built into the controller (which
senses airflow triggered by a standard hand-
gun) or via a single discrete remote I/O trigger
signal. In REMOTE mode, the selection and
adjustment of the set point can be performed
using either discrete or analog remote I/O
signals. Two tripleset signals are provided
that can be used to select one of the same
three presets that are set and used in LOCAL
mode. Two analog remote I/O set point
signals are provided, one for current and one
for voltage, and can be used to control the set
point (See the Operation portion of this
Manual for more information). The REMOTE
mode triggering of HV is performed using a
single discrete remote I/O trigger signal.
SAFETY FEATURES
When used with the appropriate applicators
and cascades, the Ransburg 9060 High
Voltage Controller provides maximized opera-
tional safety. The protections include detection
of Boot Faults, Ground Faults, Cable Faults,
DISPLAYS
The front panel displays the high voltage set
point as well as a reading of the gun current
output. The gun current is derived from feed-
back signals in the low voltage cable be-
tween the controller and the cascade.
Figure 1: 9060 High Voltage Controller
Feedback Signal Faults, Overvoltage, and
Overcurrent. The microprocessor circuits
provide a controlled output load curve, which
limits the high voltage output to safe levels
while monitoring control and feedback
signals for unsafe conditions. Maximum
operational safety is obtained when the
correct applicator settings are used and
when safe distances between the applicator
and target are observed and followed. The
maximum efficiency of the high voltage
controller is based on load.
Part #: Description
80100-21X Non-Approved for use with Evolver SE
80100-31X Atex Approved for use with Esta-Quick
80100-41X Non-Approved for use with Evolver SE
80100-51X Atex Approved for use with Aerobell 168
The 9060 High Voltage Controller (80100-
XXX) is available as follows: