Ranger Products RX3040, Инструкция по установке и эксплуатации

Страница: 54 / 74

54
ADJUSTMENT OF TOOL HEAD
TARGET LOCK™ LIMIT SWITCH
1. Mount an empty rim onto the turntable.
2. Lower the Upper Bead Breaker Roller to within about
an inch of the tire Rim.
3. Use the Center Post Control and the Upper Bead
Breaker Control to bring the Upper Bead Breaker Roller
to within 1/8”-1/4’ of the Rim edge. (See Fig. 17.5)
4. Retract the Tool Head Arm and raise it to it’s highest
position.
5. Flip Tool Head so that Tab Side is pointing UP.
6. Turn Power off at the machine and LOCK OUT TAG /
OUT the machine while performing the Limit switch
adjustment.
WARNING!
KEEP HANDS CLEAR!
KEEP HANDS CLEAR OF ALL COMPONENTS
OF THE TIRE CHANGER WHEN ROTATING
TURNTABLE DURING MOUNTING PROCEDURES.
THERE ARE MANY PINCH OR CRUSH HAZARDS
IF HANDS ARE KEPT IN CONTACT WITH THE
MACHINE DURING DEMOUNTING ROTATION.
NOTE!
REVIEW SECTION 6-8 FOR DETAILS ON
CONTROLS AND MOVEMENT OF BEAD BREAKER
ROLLER AND TOOL HEAD.
CAUTION!
ANY TIME THE TOOL HEAD IS CHANGED FROM
THE STEEL HEAD TO PLASTIC OR VICE VERSA,
THE STOP POSITION OF THE TOOL HEAD MUST
BE ADJUSTED.
WARNING!
DISCONNECT, TAG AND LOCK OUT POWER
SOURCE BEFORE ATTEMPTING TO INSTALL,
SERVICE, RELOCATE OR PERFORM ANY
MAINTENANCE.
Fig. 17.5