Ranger Products RX3040, Инструкция по установке и эксплуатации

Страница: 12 / 74

12
Anchoring
1. It is not essential to anchor the machine to the floor,
however, the floor must be smooth and level. When
anchoring to a concrete floor use the mounting holes that
are provided in the frame. Make sure the machine is solid
and level and supported evenly on all anchor points. Solid
shims may be used if necessary. (See Fig. 6.9)
Assembly
1. Bolt the Tire Carrier onto the bottom of the Tire Lift.
(See Fig. 6.9)
2. Remove the tie downs holding the Assist Arms in
place.
3. Remove the Quick Nut and Mounting Cones from the
Center Post.
4. Place the Mounting cones, and Quick Nut on the
accessory hangers mounted on the sides of the machine
5. Place the Tire Lubricant Container Bracket and place
it in the holes on the side panel. Fill the container with
Tire manufacturer’s recommended lubricant.
Proper unit installation is necessary for safe use
and efficient operation. Proper installation also
helps protect the unit from damage and makes
service easier. Always keep this manual with unit.
DANGER!
FAILURE TO PROPERLY INSTALL THE MACHINE
CAN LEAD TO IMPROPER AND UNSAFE
OPERATION.
NOTE:
Be sure to remove the Small Cone from the Turntable
as it can drop below the Turntable and cause some
wheel mounting difficulty. (See Fig. 6.11)
Fig. 6.8
Fig. 6.10
Fig. 6.11
Fig. 6.9