Ranger Products RX3040, Инструкция по установке и эксплуатации

Страница: 52 / 74

52
SECTION 17
MAINTENANCE INSTRUCTIONS
Read and follow all the maintenance instructions provided
in this manual to keep the machine in good operating
condition. Regular inspections and proper maintenance
are essential to preventing accidents and injuries. These
instructions will help you service the unit. Instructions are
for a person with some mechanical ability and training. No
attempt has been made to describe all basic steps like
how to loosen or tighten fasteners. Basic procedures such
as cycling systems and checking operation of the
equipment are not fully described here since they are
described in other sections of this manual. Do not attempt
to perform work beyond your ability or at which you have
no experience. If you need assistance, call an authorized
service center or contact the factory.
DAILY
t
Check the tire pressure gauge function daily, and
check the accuracy monthly. Use a pressurized tire and a
high quality stick or digital -type pressure gauge. If neces-
sary, adjust the dial of the machine gauge. If the gauge is
defective, replace it immediately.
t
Make sure all fasteners are securely tightened and all
guards and covers are in place.
t
Check for worn, damaged or missing parts including
grips and protective covers. Replace them before allowing
the unit to be used.
t
Check the tire pressure gauge function daily, and
check.
t
On a daily basis, inspect the unit and check to be
certain that all systems are operating normally. Follow
detailed inspection and testing procedures as specified for
various components at regular intervals.
t
Replace any damaged or missing safety decal’s. They
are available from the factory.
WEEKLY
Water Separator/Lubricator Maintenance
Check oil and water levels regularly, and perform these
maintenance items weekly:
t
Observe the sight glass on the water separator/filter
unit. If water is observed, drain by pressing upwards on
the drain plug at the bottom of the reservoir.
t
Disconnect air supply to machine.
t
Add oil to the lubricator if the fluid level is below the
middle of the sight glass. Remove the reservoir by turning
counter-clockwise and pulling down. Add SAE 10W
non-detergent oil or an air tool oil if necessary.
t
Reconnect the air when service/adjustments are
complete.
MONTHLY
t
Check adjustment of the Target Lock™ Tool Head
monthly. See page 54 for details
t
Check function of the inflation hose pressure
limiter/regulator monthly. Always secure/stow the cover if
adjustments are made. The pressure regulator should
never be adjusted to exceed 60 PSI. See page 56 for
details
t
Before making any inspection, adjustment, or
repair, disconnect the power source and block out
all moving parts to prevent injury.
t
Keep the machine and the immediate work area
clean. Do not use compressed air to remove dirt and
debris from the machine. Foreign material may be
propelled into the air and into operator or bystander
causing personal injury.
t
Wear protective clothing and use eye
protection when making any adjustments or repairs
to the machine.
NOTE!
REFER TO SECTION 9 PAGE 26 FOR DETAILS
OF AIR OIL REGULATORS ADJUSTMENTS.