Ranger Products R980X, Инструкция по установке и эксплуатации

Страница: 35 / 52

Air Drier /Oiler Maintenance
Check oil and water levels regularly, and perform these
maintenance items weekly:
t
Observe the sight glass on the water separator/filter
unit. (See Fig. 17.4)
t
If water is observed, drain by pressing up on the drain
plug at the bottom of the reservoir. (See Fig. 17.5)
t
Disconnect air supply to machine. (See Fig. 17.6)
t
Add oil to the lubricator if the fluid level is below the
middle of the sight glass. Unscrew the Fill Cap, Add SAE
10W non-detergent oil or an air tool oil if necessary.
(See Fig. 17.7)
3. Reconnect the air supply when service/adjustments are
complete.
NOTE:
This adjustment will require two persons to perform.
1. With the Air source connected, depress the Bead
Breaker Pedal to operate the Bead Breaker.
2. Observe the site glass and adjust the oil flow of the
oiler by turning the Oiler Adjustment knob so that 2-3
drops of oil drip through the site glass for each operation
of the Bead Breaker Pedal. (See Fig 17.8)
(Either reservoir may be removed for cleaning by turning
the reservoir counter-clockwise and pulling down.)
35
IMPORTANT!
Failure to maintain the Water Separator/ Air Oil
regulator in proper condition may void warranty.
Drain water out of the system regularly
and keep the Oil reservoir filled.
Fig. 17.4
Fig. 17.5
Fig. 17.6
Fig. 17.7
Fig. 17.8