Ranger Products R980X, Инструкция по установке и эксплуатации

Страница: 20 / 52

Wheel Clamp Adjustments
9. Place the Wheel Protections pads on the Wheel Clamps
if desired when clamping from the outside. (See Fig. 11.5)
10. Place tire/wheel assembly on Table Top with mounting
side up. (See Fig. 11.6)
11. Use the Wheel Clamp Foot Pedal to move the Clamps
inward (pedal down) or outward (pedal up).
(See Fig. 11.7 & 11.8)
12. Apply tire manufacturer’s approved rubber lubricant liber-
ally to entire circumference of both upper and lower beads
after loosening bead and placing on table top.
(See Fig. 11.9)
13. After the wheel is secured to the Turntable, pull the
Overhead Swing Arm into position, use the large adjusting
knob to position the Mount/Demount Head directly over
the edge of the rim.
(See Fig. 11.10)
20
NOTE:
Clamp steel wheels from the inside (clamps
push outward against wheel). Clamp mag and
custom wheels from the outside (Clamps push
inward against the outside rim edge). Refer to the
Performance Tires and Wheels section.
Fig. 11.5
Fig. 11.6
Fig. 11.7
Fig. 11.8
Fig. 11.9
Fig. 11.10
WARNING!
THE RIM AND BEAD MUST BE LIBERALLY
LUBRICATED. FAILURE TO USE AN ADEQUATE
LUBRICANT CAN LEAD TO THE BEAD BINDING ON
THE RIM AND LEAD TO DAMAGE TO THE MOTOR
AND OR VOID THE WARRANTY.