
Remote Control Commands
R&S
®
NRPxxS(N)
94
User Manual 1177.5079.02 ─ 10
Using
[SENSe<Sensor>:][POWer:][AVG:]FAST
ON
, you can accelerate the mea-
surement as follows:
●
Chopper is deactivated.
●
Average count is set to 1, no matter which average count you have set.
Thus, the overall measurement time is only defined by the aperture time, and the mea-
surement time for a fast measurement is calculated as follows:
MT = APER
A programming example is given in
Chapter 10.2, "Performing the Fastest Measure-
ment in Continuous Average Mode"
Remote commands:
[SENSe<Sensor>:][POWer:][AVG:]APERture
......................................................................94
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:CLEar
...............................................................94
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:COUNt?
............................................................94
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:DATA?
.............................................................. 95
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:SIZE
.................................................................95
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:STATe
...............................................................95
[SENSe<Sensor>:][POWer:][AVG:]FAST
............................................................................ 95
[SENSe<Sensor>:][POWer:][AVG:]SMOothing:STATe
.......................................................... 96
[SENSe<Sensor>:][POWer:][AVG:]APERture
<integration_time>
Sets the duration of the sampling window in the continuous average mode. During this
time interval, the average signal power is measured.
Parameters:
<integration_time>
Range:
10.0e-6 to 2.00
*RST:
0.02
Default unit: Seconds
Example:
APER 0.02
Manual operation:
See
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:CLEar
Clears the contents of the result buffer in continuous average mode.
Example:
BUFF:CLE
Usage:
Event
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:COUNt?
Queries the number of results that are currently stored in the result buffer. Available in
continuous average mode.
Example:
BUFF:COUN?
Usage:
Query only
Configuring the Measurement Modes