R&S NRP18S, Руководство пользователя, Страница: 24 / 184

Power Sensor Tour
R&S
®
NRPxxS(N)
24 User Manual 1177.5079.02 ─ 10
Table 4-1: R&S NRPxxS(N) RF connector characteristics
Power sensor Male connector Matching female con-
nector Tightening torque
R&S NRP8S
N N 1.36 Nm (12'' lbs)
R&S NRP8SN
R&S NRP18S
R&S NRP18SN
R&S NRP33S
3.50 mm 3.50 mm/ 2.92 mm/ SMA
0.90 Nm (8'' lbs)
R&S NRP33SN
R&S NRP33SN-V
R&S NRP40S
2.92 mm 3.50 mm/ 2.92 mm/ SMA
R&S NRP40SN
R&S NRP50S
2.4 mm 2.4 mm/ 1.85 mm
R&S NRP50SN
4.2 Trigger I/O Connector
The trigger I/O is a connector of SMB type.
It is used as an input for signals if the trigger source parameter is set to
EXTernal2
. It
is used as an output for trigger signals if the sensor is operated in the trigger master
mode.
Further information:
●
Chapter 9.5.2, "Triggering" , on page 73
4.3 Host Interface
The host interface connector is used for establishing a connection between the power
sensors and a USB host or a supported Rohde
& Schwarz instrument. For this pur-
pose, an external cable is needed. Two types of cables are available:
●
R&S NRP
‑
ZKU cable with a USB connector, for connecting the power sensor to a
USB host device (R&S order number 1419.0658.xx).
●
R&S NRP
‑
ZK6 cable with a push-pull type connector, for connecting the power
sensor to a base unit, R&S NRX or R&S NRP2, or other Rohde & Schwarz prod-
ucts with the round connector (R&S order number 1419.0664.xx).
These cables can be obtained in different lengths up to 5 meters.
Host Interface