Rancilio EGRO 55 Series, Техническое руководство

Страница: 15 / 114

- Section 2: Page 3 -
E55_TM_S2_InstallV3
©
Copyright 2008. Rancilio North America
EGRO 55 SERIES TECHNICAL MANUAL
2.2 INSTALL FEET ON MACHINE AND KS FRIDGE
(WITH MODEL 5513)
The Egro 55 Series machine comes with riser feet to provide adequate space to easily clean beneath the machine. The Egro
Model 5511 comes with 4 fee, and the 5513 with a KS Fridge comes with 8 feet, four for the machine and four for the fridge.
PLEASE NOTE: It is recommended that two people perform that steps below.
INSTALLING THE FEET:
TIP: The Egro rubber on the bottom of the legs is slightly different in the front and the back. One set of rubber feet bottoms
is smoother than the other. You may wish to use these in the back of the machine, so that sliding the machine on a counter
top will be easier.
1. Locate the four or eight (with fridge) feet provided.
2. Slowly tilt the Egro 55 machine or KS fridge to the right, and
screw in two legs (one front and one back) to the bottom left side.
3. Carefully tilt the machine onto the newly installed legs and screw in the
remaining two legs to the bottom right side.
2.2 - 2.12 INSTALLATION INSTRUCTIONS: STEP BY STEP GUIDE
2.3 INSTALL BEAN HOPPERS
INSTALLING THE HOPPERS:
1. Locate the two bean hoppers provided with the machine.
2. Slide the hoppers down into the rubber grinder collars located on the top
of the machine.
TIP: If necessary gently rock the grinders front to back while pressing downward into the
rubber collar.
PLEASE NOTE: No screws or other fasteners are required for installation.
3. After installing the hoppers, fi ll them with fresh coffee beans.
- Fill LEFT HOPPER with REGULAR BEANS
- Fill RIGHT HOPPER with DECAF BEANS
EGRO FOOT
TOP VIEW OF
MACHINE WITH
GRINDER COLLARS
CIRCLED