RAMSET D45, Инструкция по безопасности и эксплуатации оператора

Страница: 13 / 16

PARTS LISTING / MAINTENANCE
PARTS LISTING / MAINTENANCE
13
D45 TOOL PARTS LIST
KEY PART NO. DESCRIPTION
1 323300 MUZZLE BUSHING ASSEMBLY
2 316520 BUFFER
3 306450 PISTON
4 323310 BARREL RETENTION COLLAR ASS’Y
5 316540 PAWL ( 2 )
6 323390A BARREL ASSEMBLY
7 323940 RECEIVER ASSEMBLY
8 308490 LATCH BUTTON ASSEMBLY
9 13510 COVER ASSEMBLY
10 307890 FIRING PIN ASSEMBLY
11 13593 FIRING PIN SPRING
12 312590A COLLAR RET. RING AND BALL
13 323050A RETENTION CLIP AND BALLS
14 316570 FIRING PIN PAWL AND SPRING
15 13518 INDEXING LEVER AND SPRING
16 13516 TRIGGER LOCK ASSEMBLY
17 316580 SEAR ASSEMBLY AND PIN
18 309280 REAR HANDLE ASSEMBLY
19 308860 REAR HANDLE SCREWS AND NUTS
20 13509 TRIGGER AND PIN
21 12266 SPALL GUARD ( NOT SHOWN )
22 351000 MUZZLE BUSHING O-RING
23 351001 RETENTION COLLAR O-RING
MAINTENANCE
IMPROPERLY MAINTAINED TOOLS CAN CAUSE SEROIUS INJURIES
TO TOOL OPERATORS AND BYSTANDERS
CLEAN TOOL DAILY
Always make sure the tool is not loaded before performing any service or
repair and always wear safety goggles when cleaning or servicing the tool.
NORMAL CLEANING
All front end parts shown in the disassembly section are to be cleaned daily with a
good detergent oil and wire brush. Remove all dirt and carbon buildup and wipe
parts dry with a clean rag. Check all parts for wear or damage before reassembly
and replace or repair any worn or damaged parts.
COMPLETE CLEANING / GENERAL MAINTENANCE
Heavy use or constant exposure to dirt and debris may require that the tool be
cleaned more extensively. Complete disassembly and cleaning of all parts may be
necessary to restore the tool to normal operation. General maintenance should be
performed every six months or more often if the tool is subjected to heavy use.
Contact your authorized Ramset Distributor for assistance.
ALWAYS FUNCTION TEST THE TOOL AFTER PERFORMING ANY SERVICE.
SEE PAGE 9 FOR DETAILS ON THE FUNCTION TEST.