RAMSET D45, Инструкция по безопасности и эксплуатации оператора

Страница: 11 / 16

TROUBLESHOOTING
TROUBLESHOOTING
11
REFER TO PARTS SCHEMATIC FOR PROPER ASSEMBLY OF PARTS
- Overdriving of fasteners - Excessive power - Change to next lower
power level load disc
color and number.
- Soft base material - Check base material
(see page 3)
- Tool fails to fire - Failure to depress - See “ Tool does not
completely completely depress”
- Excessive dirt buildup - After following misfire
on breech face not allow- procedure, check firing
ing proper penetration of pin indentation on load.
firing pin Clean breech face
- Firing pin and/or breech - Replace damaged parts
damaged
- Tool does not completely - Misassembled or damaged - Check all parts in the
depress parts receiver for damage or
improper assembly.
- Reduction or loss of - Piston not being returned - Barrel must be pulled
power to the full rear position completely open to
properly reset the
piston.
- Worn or damaged piston or - Replace worn
piston ring or damaged parts
- Worn or broken pawls - Replace pawls
- Tool cannot be cocked or - Excessive dirt buildup - Clean tool thoroughly
opened
- Damaged or bent piston - Replace piston
- Broken or damaged parts - Tag tool with warning
“Defectine- Do Not Use”
Place in a locked con-
tainer and contact your
ITW Ramset/Red Head
representative for
service.
- Failure to index disc - Disc not inserted in tool - Check load disc
correctly or is damaged Properly dispose of
damaged disc (see
page 6)
- Damaged indexing - Contact your ITW
mechanism Ramset/Red Head
distributor for
assistance.