DISASSEMBLY
DISASSEMBLY
15
SLIDE BARREL ASSEMBLY
FROM MUZZLE BUSHING
5.
Slide the barrel assembly away from
the muzzle bushing.
6. Remove the piston from the muzzle
bushing.
7. Remove the buffer from the muzzle
bushing.
8. Inspect all parts for wear or damage
and clean or replace as required.
Use detergent oil and cleaning brush.
Wipe parts dry before reassembly.
WEAR SAFETY GOGGLES WHEN
CLEANING TOOL PARTS.
9.
Check the piston tip for mushroom-
ing or other deformities, and grind
flat. The tip of the piston must be 90°
to the shank and grinding must only
be done by qualified personnel. The
overall minimum length of the piston
must not be less than 5 11/16”. When
less than this length, the piston must
be replaced to avoid tool damage.
10. Reassemble the tool in the reverse
order of disassembly.
ALWAYS PERFORM THE DAILY
FUNCTION TEST BEFORE
USING THE TOOL AFTER
CLEANING OR SERVICING.
PULL PISTON OUT OF THE
MUZZLE BUSHING
PULL BUFFER OUT OF THE
MUZZLE BUSHING
GRIND PISTON TIP FLAT AND
BEVEL THE TIP EDGE AT 18°
Содержание D45
Страница 12: ...PARTS SCHEMATIC PARTS SCHEMATIC 12...
