TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
9
TOOL OPERATION
Daily Function Test
Always check the tool first to make
sure that it does not contain a load
disc or fastener.
Test the tool several
times by depressing the muzzle bushing
fully on a hard surface and pulling the
trigger. You should hear an audible click
as the firing pin releases.
PERFORM FUNCTION TEST
WITH EMPTY, UNLOADED TOOL
OPEN BARREL AND CLOSE TO
SEMI-CLOSED POSITION
INSERT FASTENER INTO THE
MUZZLE END OF THE TOOL
WITH THE POINT OUT
OPERATING THE D45 TOOL
1.
After checking to be sure that
the tool is not loaded, point it in a
safe direction and be sure that
the barrel is fully extended. This
assures that the piston is in
position for the next fastening.
Use the spall guard every time
possible to minimize the risk of
being struck by flying debris.
2.
With finger off the trigger, place
the fastener, point out, into the
muzzle end of the tool until the
point end is inside the muzzle.
NEVER
load a fastener with
your finger on the trigger.
DO
NOT
use excessive force when
inserting a fastener.
STOP
immediately if excessive force is
required, inspect the barrel to
find out why the fastener is not
entering the muzzle freely.
DO
NOT
continue loading unless
the problem is corrected.
3. With the tool pointed in a safe
direction and finger away from the
trigger, open the cover by pressing
the side button and insert a load
disc into the slots in the receiver
housing.
INSERT LOAD DISC INTO THE
SLOTS IN THE RECEIVER
HOUSING
Содержание D45
Страница 12: ...PARTS SCHEMATIC PARTS SCHEMATIC 12...